primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• The terminal P2 of the primary winding is used as the static contact in the switch cabinet and it is with contact box.
  本系列电流互感器为全封闭环氧树脂浇注结构，其一次绕组的P2端直接作为开关柜中的静触头，并带有触头盒。
• The harmonic compensation currents proportional to the harmonic current in the primary winding, which is detected real-timely, are injected to the multiple secondary winding of the transformer.
  实时检测变压器原方绕组的谐波电流，通过逆变器产生与原方绕组谐波电流成比例的谐波补偿电流注入变压器副方多补偿绕组中。
• With consideration of ST's insulation and volume, the parameter of ST was determined by the theory analysis and computation of the primary winding.
  通过对初级绕组的计算分析及考虑体积、绝缘的基础上，确定了ST的相关参数。
• Rising Current Method at CT Primary Winding and Its Application
  电流互感器一次升流的方法与应用
• Considering the conditions as voltage at primary winding, shortcircuit forces of windings and turns for transformer were calculated with FEM coupling circuit method under the 2D symmetrical model.
  以此起始条件设定变压器原边电压激励，利用磁路-电路耦合有限元法建立了2D轴对称模型，计算了变压器原、副边线圈及各线匝短路电磁力。
• The inductance of primary winding, secondary winding and the mutual inductance between two windings of the models are calculated by solving the 3D magnetostatic field in the models.
  通过计算带抽能线圈并联电抗器模型的三维静磁场，得到带抽能线圈并联电抗器模型的一次、二次线圈的电感和互感等参数。
• The strength calculation method and the structure of current transformer with U primary winding to fulfil the dynamic stability requirements are introduced, and some calculating examples are given.
  介绍了U形一次绕组电流互感器可满足动稳定要求的结构及强度计算方法，并给出了计算实例。
• The High Tension ( HT) voltage is produced by mutual induction between the primary winding and the secondary winding, and the central soft iron core intensifies the magnetic field between them.
  通过初级绕组和次级绕组之间的互感产生出一个高电压，把两绕组联系起来的中心软体起导磁的作用，它把磁场集中起来。
• And finally, on the basis of the magnetic integration, the application of passive integration technology, through staggered parallel structure in the primary winding of transformer in the integrated resonant capacitor, through the Maxwell 2D simulation software to validate the correctness of the design.
  最后，在平面磁集成结构的基础上，应用无源集成技术，通过交错并联结构在变压器原边中集成谐振电容，并通过Maxwell2D仿真软件验证设计的正确性。
• Through various short-circuit current temperature rise test results, the transformer temperature, time, and a high degree of three curves, obtained directly within the thermal region transformer primary winding height of about 83.3%.
  通过在不同短路电流条件下的温升试验，得到了变压器内部的温度与时间、纵向高度之间的关系曲线，得出变压器内部热区域主要集中在约绕组自下而上高度的83.3%区域。